A sample thief (also called a sampling thief) is a hollow tube that you push into a drum, bag or tank to pull out a spot sample from a known depth. Liquid thieves are open tubes or valve tubes that trap liquid; powder thieves are two-part tubes whose inner tip is exposed at depth, filled, then closed. Choosing one comes down to what you are sampling (thin liquid, viscous liquid or free-flowing powder), how deep the container is, how much sample you need and whether the sampler is reused or thrown away. This guide compares the drum thief and powder thief options ERE Inc. supplies.
In this guide
- What is a sample thief and how does it work?
- Which thief samples liquids from a drum?
- Which thief samples powders and granules?
- How do you choose the right size?
- What can a thief not do?
- How to choose a sample thief
- Frequently asked questions
What is a sample thief and how does it work?
A sample thief is a hand-held tube that lifts a small, defined portion of material out of a container without opening it fully or pouring it. It is the standard tool for checking incoming drums, totes and bags against a specification before they are accepted or processed.
There are two working principles. A liquid thief is lowered into the liquid, fills from the open end or through a valve, and is then lifted out with the sample held inside. A powder thief has an outer tube and an inner tip: you push it in closed, pull the outer tube up at the depth you want so powder flows around the tip, push the tube down to trap the sample, and withdraw it.
For larger or more complex liquid jobs, see our guide to drum and tank liquid sampling equipment; for full-depth liquid columns, the coliwasa sampler guide covers the next step up.
Which thief samples liquids from a drum?
For thin liquids, an open-ended glass or HDPE drum thief is the simplest and lowest-cost option: you lower the tube, cover the top end with your thumb, lift it out and release the sample. For water-like or viscous liquids sampled at depth, a disposable valve thief such as the SteriWare LiquiThief or ViscoThief gives a more controlled sample.
- Glass Drum Thiefs (Conbar) are borosilicate glass, 42 in. long, in 0.36 in. (50 ml), 0.45 in. (100 ml), 0.63 in. (150 ml) and 0.70 in. (200 ml) outside diameters, standard or pre-cleaned. Glass suits solvents and aggressive liquids where plastic would not.
- HDPE Plastic Drum Thief (Conbar) is the open-ended polyethylene version for small-volume, low-cost sampling of drums, transformers and other liquid containers. It is 42 in. long in 50, 100 and 150 ml sizes and comes standard, pre-cleaned, sterilized or anti-static.
- SteriWare LiquiThief (Sampling Systems) is a disposable thief for low-viscosity liquids such as water: pull the handle to draw the sample in, withdraw, push down to expel. It comes in 100 ml / 500 mm, 190 ml / 1,000 mm and 300 ml / 1,500 mm sizes, individually bagged, in sterile or non-sterile versions.
- SteriWare ViscoThief is the viscous-liquid version, for oils, creams, shampoo and honey, with a 10 mm tip hole and sample volumes of 100, 190 and 290 ml.
All are listed in the liquid sampling collection. Confirm the material against your liquid on the product data sheet before use.
Which thief samples powders and granules?
For free-flowing powders and granules, use a two-part powder thief. Choose reusable 316L stainless steel for repeated sampling with a cleaning step, a disposable HDPE thief for single-use or sterile work, or a multi-cell thief to pull samples from several depths in one pass.
- Powder Thief (Sampling Systems) is 316L stainless steel with interchangeable tips sold separately. Bodies are 12.5 mm (0.25 to 1.5 ml tips), 19 mm (2 to 10 ml), 25 mm (10 to 25 ml) and 32 mm (20 to 100 ml), in lengths from 300 mm to 2,000 mm.
- SteriWare Powder Thief is the disposable version: cleanroom-assembled HDPE, individually bagged, with full batch traceability and sterile (SAL 10-6) or non-sterile options, in seven sample volumes from 0.5 ml up to 20 ml.
- Multi-Thief with Interchangeable Inserts is 316L stainless, 40 mm in diameter in 1,000, 1,500 and 2,000 mm lengths. You fit 5 to 60 ml sampling inserts, turn the handle to expose the cells to the product, turn it back and withdraw.
- AccuPod Sample Thief is built for unit-dose sampling of powders and granules, used in blend uniformity and general quality control work.
Browse the full range in the powder samplers collection.
How do you choose the right size?
Start from the container and the sample you need. The thief has to be longer than the container is deep, and its tube or tip volume has to give at least the amount the lab asks for.
| Material | Thief | Sample volume | Length |
|---|---|---|---|
| Thin liquid, small volume | HDPE or glass drum thief | 50 to 200 ml | 42 in. |
| Water-like liquid, controlled | SteriWare LiquiThief | 100 to 300 ml | 500 to 1,500 mm |
| Viscous liquid | SteriWare ViscoThief | 100 to 290 ml | 500 to 1,500 mm |
| Free-flowing powder, reusable | 316L Powder Thief | 0.25 to 100 ml | 300 to 2,000 mm |
| Powder, single-use or sterile | SteriWare Powder Thief | 0.5 to 20 ml | 500 mm and longer |
| Powder, several depths | Multi-Thief | 5 to 60 ml per insert | 1,000 to 2,000 mm |
Figures come from the product listings; confirm exact part numbers and ranges on the data sheet when you order.
What can a thief not do?
A thief gives a spot sample, so it cannot tell you whether the whole container is uniform. For layered liquids, a full-depth sampler such as a coliwasa is the better tool, and for solids that are caked, wet or cohesive a free-flowing powder thief will not fill properly.
For waste, drum and regulatory work, the sampling plan matters as much as the tool. The U.S. EPA's sampling questions page lists the standard drum-sampling references: ASTM D5680 for unconsolidated solids in drums, ASTM D5743 for single or multilayered liquids in drums, ASTM D6063 for sampling drums by field personnel, and SW-846 Chapter Nine. EPA also notes that composite samples should not be used when drum-to-drum variability matters. In Canada, label any sample container under your site's workplace labelling procedures; see CCOHS on WHMIS.
Reusable thieves must be cleaned between samples. EPA's page points to ASTM D5088 for decontaminating field equipment used at waste sites; disposable thieves remove that step.
How to choose a sample thief
- Identify the material. Thin liquid, viscous liquid, or free-flowing powder or granules.
- Measure the container depth. The thief must reach the depth you need to sample.
- Set the sample volume. Match the tube diameter or tip to the amount the lab requires.
- Choose reusable or disposable. Stainless steel or glass for repeat use with decontamination; HDPE disposables for single use or sterile work.
- Check material compatibility. Glass, HDPE and 316L resist different chemicals; confirm on the data sheet.
- Plan documentation. Record depth, thief and sampler so the sample can be traced.
Not sure which thief fits your drum or powder? Request a quote with the material, container size and sample volume, and we will match the body and tip, or call us in Montreal.
Need help choosing a sampler?
ERE Inc. has been Canada's environmental and safety equipment specialist for 30+ years. Talk to a real specialist about your material, containers and sampling plan.
→ Request a Quote | 1-888-287-EREC | Browse Liquid Sampling | sales@ereinc.com
Frequently Asked Questions
What is a sample thief used for?
A sample thief pulls a small spot sample from a drum, tote, bag or tank without emptying it. It is used for incoming-goods checks, quality control and waste characterization, with liquid thieves for liquids and two-part powder thieves for free-flowing powders and granules.
What is the difference between a drum thief and a powder thief?
A drum thief is an open tube that traps liquid when you cover the top end with your thumb. A powder thief has an outer tube and inner tip: you open it at depth to let powder in, close it to trap the sample, and withdraw it.
Is a disposable or a stainless steel thief better?
Disposable thieves avoid cross-contamination and arrive cleaned or sterile, which suits pharmaceutical, food and cosmetic work. Stainless steel 316L thieves cost more up front but last for repeated sampling, provided they are decontaminated between samples.
How much sample does a thief take?
It depends on the model. The powder tips we stock range from 0.25 ml to 100 ml, the SteriWare powder thief from 0.5 to 20 ml, and the drum and liquid thieves from 50 ml to about 300 ml. Confirm the exact volume on the product listing.
Related articles
- Drum and tank liquid sampling: equipment and methods
- Coliwasa samplers: types, use and selection guide
- Drum pumps: how to choose a hand pump for 55-gallon drums
Lire en français : Sonde d'échantillonnage (thief) : fûts et poudres, types et choix au Canada